BioProTT
TM
Flow Measurement System Version 1.00 page 30 of 75
6.5 Mounting
BioProTT flow meters with standard industry housing are designed as table top devices
which can be stacked, e.g. like a pump tower.
It is also possible to fix the flow meter with screws using the threaded sleeve of each of the
foot pieces. See below diagram for exact measurement.
Screws with an M3 screw thread (ISO Metric Coarse Thread DIN 13) need to be used. A
screw-in depth of at least 4.5 mm and a maximum of 5 mm from the outer edge of the
thread is required.
Figure 13: Bottom view of BioProTT FlowTrack and BioProTT FlowTrack plus
Figure 14: Drill template – all values in [mm]
To Next Page
Loading...