6 CRO V (surge)
7 HV pulse Burst output 50
8 Coupling (Power, Burst, Surge)
9 EUT test supply
10 Ground reference (calibration)
9 EUT test supply
For single-phase EUT the coupling/decoupling network is part of the generator. The EUT is powered via the
safety banana plugs at the front panel of the simulator.
10 Ground reference
The ground reference (4mm) is used for EFT/Burst calibration adapters.
11 BNC - CRO Trigger
At the BNC output the generator trigger can be checked, e.g. the burst duration, the burst repetition rate and the
spike frequency (+5 V rectangular). This output can be generally used as oscilloscope trigger output and is
synchronous to the following events.
- Burst and surge release
- Voltage dip or interruption, start of the event.
12 START / PAUSE button
- Green indication: Start or continues a test
- Orange indication: Pause of a running test
13 STOP / Pause button
- Red indication: Stop a running or paused test.
14 BACK button
- Returns from a stopped test to the input screen.
- Same effect with two fingers swipe on the screen, slide them from right to left
15 USB input (Memory Stick)
Input plug for a memory stick for export / import test reports or test and link-files. The user can load from this port
setup pictures, updates and other files to the Compact NX5 generator.