Setup
The Setup menu is the place where the user configures his test equipment and device behavior.
General: Setup menu for the NX system
Equipment: Setup menu for equipment’s connected to the NX test generator
Overview Setup
General
System: Language, Display design, Home screen, Last test memory
Date & Time: Setting date and time with format,
Process & Sync: Ac mains synchronization, timeout for sync and trigger, Power frequency detection,
HV-COM 18 µF capacitor
Display: Brightness
Sounds & Signals: Loudspeaker volume; Surge countdown; Trigger waiting; Test running; Test finish
Application: Surge coupling to HV-COM output with 18 µF enable
Report: Report settings implemented from V 3.0.0 and higher
Remote: IP address, subnet mask, gateway, MAC address
Equipment’s
Devices and Modules List of all available Devices and Modules like Burst, Surge, Telecom Surge, Power
Fail, Magnetic Field, Ringwave…
External Couplers: 3-phase coupling networks, Magnetic field antennas
Transformers: Variac transformers, tapped transformers, H-field ac transformers
Language: Selection English (default), German, Italian,
Polish, …
Color: Color design of the display selection
Color, Grey
Home screen: Design of the home screen
Panels Carousel
Remember last test:
Enable: When enter in any test menu; the software
will automatically load the same test that was used
last time in this menu.
Disabled: Load the selected test in the menu.
FACTORY SETTING
Sets all parameters to the factory settings, even the
messages.
To Next Page
Loading...
Need help?
General
