EM TEST CWS 500D - Delivery Groups; Basic equipment; Options and Accessories

EM Test CWS500 D
User manual V 1.07 32 / 34
9. Delivery Groups
9.1. Basic equipment
- Continuous wave simulator type CWS 500D
- Mains cable
- Manual CWS 500D on delivered CD
- Calibration certificate
- ICD software available on CD
- Cable with N type connectors
9.2. Options and Accessories
Accessories
C-IEEE IEEE cable for CWS computer interconnection
Set C-BNC BNC cable for current monitor probe
AD-N-BNC N to BNC adapter for ATT20/15
Options
ATT3/100 Attenuator for BCI, 3dB /100W
ATT20/15 2 x 20dB/15W attenuator for current monitor path
T-50 A 50 Ohm / 6 W matching resistor
BCI set of clamp, fixture and monitor probe for MIL461E DO160
F-120-6A Clamp-on injection probe, 10kHz - 400MHz, 40mm
FCC-BCICF1 Injection probe calibration fixture (jig) for F-120/F130 probe types
F-55 Clamp-on monitor probe, 10kHz - 500MHz, 32mm diameter
ATT 6/75 Attenuator 6dB / 75 W
R-100 150 to 50 Ohm Adaptor
R-100A 150 to 50 Ohm Adaptor with N-type-connector for current clamp calibration
T-50 50 Ohm Termination
Accessories for IEC 61000-4-6 test application
KIT-IEC-6 Cable and adapater kit consisting of 2 BNC cables 25cm each, 1 BNC cable
50cm, 2 adapters N-BNC and 1 adapter BNC-N
Coupling networks ( CDN) as per IEC 61000-4-6 Wide range of different CDN’s
Coupling clamps EM clamp as per IEC 61000-4-6 for coupling of the RF signal to multiple
cables.Current injection clamp acc. To IEC 61000-4-6
Current Probe acc. IEC 61000-4-6
Cal adapters For all types of CDN’s and clamps ( manufactured and delivered by EM Test )
ATT 6/75 Attenuator 6dB / 75 W
R-100 150 to 50 Ohm Adaptor
R-100A 150 to 50 Ohm Adaptor with N-type-connector for current clamp calibration
T-50 50 Ohm Termination
Software for PC control
User software "ICD" Control, protocol, Cal measurements for different Coupling devices
Generation of analysis and documentation under windows (see separate
documentation)