Em-Trak A100 - Dash Mount Bracket Fixing Holes (Drill Drawing) (Not to Scale); GNSS Antenna Drawing (Not to Scale)

Drawings
Page 75
7.3 Dash mount bracket fixing holes (drill drawing) (not to scale)
7.4 GNSS antenna drawing (not to scale)*
* An equivalent alternative GPS antenna may be supplied with transceiver variants without the dual mode
internal GNSS receiver. The dimensions of the supplied antenna may vary from those shown here.
120.0mm
40.0mm
Drill for screw size No. 8 (4-PL)
Tap drill size No. 29 (3mm drill is sufficient)
68mm
75mm
TNC (male)
TNC (male)
10m RG58 cable