nas_connecthome
145
The nas Commands
[-email_to <email_addr>[ ,<email_addr> ] ]
Sets or modifies the destination email addresses that receive the
event files. Multiple email addresses can be specified with a
comma separating each address. The maximum number of
characters that can be specified is 255.
Note: Specifying "" (empty double quotes) reverts to the default value of
emailalert@emc.com.
[-email_subject <email_subject>]
Sets or modifies the subject of the email message.
Note: Specifying "" (empty double quotes) reverts to the default value of
CallHome Alert.
[-email_server {<hostname>|<ip_addr>}]
Sets or modifies the primary email server that accepts and routes
email messages.
Note: Specifying "" (empty double quotes) disables the use of the existing
email server for this transport mechanism.
[-email_server_2 {<hostname>|<ip_addr>}]
Sets or modifies the secondary email server that accepts and
routes email messages.
Note: Specifying "" (empty double quotes) disables the use of the existing
email server for this transport mechanism.
[-dial_in_number <phone_number>]
Sets or modifies the dial-in phone number of the modem.
Note: Specifying "" (empty double quotes) does not disable the number
or restore its default value. The empty string is stored as is.
[-serial_number <serial_number>]
Sets or modifies the Celerra serial number, if it was not
automatically detected.
Note: Specifying "" (empty double quotes) does not disable the number
or restore its default value. The empty string is stored as is.
To Next Page
Loading...
Need help?
General
