EMC Celerra

nas_fs
181
The nas Commands
3 y 1 0 14 root_fs_3 2
4 y 1 0 16 root_fs_4 3
5 y 1 0 18 root_fs_5 4
6 n 1 0 20 root_fs_6
7 n 1 0 22 root_fs_7
8 n 1 0 24 root_fs_8
9 n 1 0 26 root_fs_9
10 n 1 0 28 root_fs_10
11 n 1 0 30 root_fs_11
12 n 1 0 32 root_fs_12
13 n 1 0 34 root_fs_13
14 n 1 0 36 root_fs_14
15 n 1 0 38 root_fs_15
16 y 1 0 40 root_fs_common 2,4,3,1
17 n 5 0 73 root_fs_ufslog
18 n 5 0 76 root_fs_d3
19 n 5 0 77 root_fs_d4
20 n 5 0 78 root_fs_d5
21 n 5 0 79 root_fs_d6
38 y 1 0 171 ufs2 1
40 n 1 0 175 ufs4
See Example #1 for a description of command output.
EXAMPLE #9 To extend the file system, ufs1, with the volume, emtv2b, type:
$ nas_fs -xtend ufs1 emtv2b
id = 38
name = ufs1
acl = 0
in_use = True
type = uxfs
worm = off
volume = v171
pool = clar_r5_performance
member_of = root_avm_fs_group_3
rw_servers= server_2
ro_servers=
rw_vdms =
ro_vdms =
auto_ext = no,virtual_provision=no
stor_devs = APM00042000818-001F,APM00042000818-001D,APM00042000818-0019,APM00042
000818-0016,APM00042000818-001C
disks = d20,d18,d14,d11,d17
disk=d20 stor_dev=APM00042000818-001F addr=c0t1l15 server=server_2
disk=d20 stor_dev=APM00042000818-001F addr=c32t1l15 server=server_2
disk=d18 stor_dev=APM00042000818-001D addr=c0t1l13 server=server_2
disk=d18 stor_dev=APM00042000818-001D addr=c32t1l13 server=server_2
disk=d14 stor_dev=APM00042000818-0019 addr=c0t1l9 server=server_2
disk=d14 stor_dev=APM00042000818-0019 addr=c32t1l9 server=server_2
disk=d11 stor_dev=APM00042000818-0016 addr=c0t1l6 server=server_2
disk=d11 stor_dev=APM00042000818-0016 addr=c32t1l6 server=server_2