nas_fs
183
The nas Commands
EXAMPLE #10 To extend the file system, ufs2, by the specified size of 100 GB using
clar_r5_performance pool, type:
$ nas_fs -xtend ufs2 size=100G pool=clar_r5_performance
id = 38
name = ufs2
acl = 0
in_use = True
type = uxfs
worm = off
volume = v171
pool = clar_r5_performance
member_of = root_avm_fs_group_3
rw_servers= server_2
ro_servers=
rw_vdms =
ro_vdms =
auto_ext = no,virtual_provision=no
stor_devs = APM00042000818-001F,APM00042000818-001D,APM00042000818-0019,APM00042
000818-0016,APM00042000818-001C
disks = d20,d18,d14,d11,d17
disk=d20 stor_dev=APM00042000818-001F addr=c0t1l15 server=server_2
disk=d20 stor_dev=APM00042000818-001F addr=c32t1l15 server=server_2
disk=d18 stor_dev=APM00042000818-001D addr=c0t1l13 server=server_2
disk=d18 stor_dev=APM00042000818-001D addr=c32t1l13 server=server_2
disk=d14 stor_dev=APM00042000818-0019 addr=c0t1l9 server=server_2
disk=d14 stor_dev=APM00042000818-0019 addr=c32t1l9 server=server_2
disk=d11 stor_dev=APM00042000818-0016 addr=c0t1l6 server=server_2
disk=d11 stor_dev=APM00042000818-0016 addr=c32t1l6 server=server_2
disk=d17 stor_dev=APM00042000818-001C addr=c0t1l12 server=server_2
disk=d17 stor_dev=APM00042000818-001C addr=c32t1l12 server=server_2
See Example #1 for a description of command output. The
clar_r5_performance storage pool is available with the CLARiiON
backend.
EXAMPLE #11 To set up an access control level value of 1432 for ufs1, type:
$ nas_fs -acl 1432 ufs1
id = 38
name = ufs1
acl = 1432, owner=nasadmin, ID=201
in_use = True
type = uxfs
worm = off
volume = v171
pool = clar_r5_performance
member_of = root_avm_fs_group_3
rw_servers= server_2
ro_servers=
rw_vdms =
ro_vdms =
To Next Page
Loading...
