nas_mview
203
The nas Commands
id = 2
name = server_3
acl = 1000, owner=nasadmin, ID=201
type = standby
slot = 3
member_of =
standbyfor= server_2
RDFstandby= slot=3
status :
defined = enabled
actual = online, ready
***** Servers configured as standby *****
No servers configured as standby
Where:
Value Definition
Device Group
Configuration
:
name name of the consistency (device) group
description brief description of device group
uid UID assigned, based on the system
state state of the device group (for example, Consistent, Synchronized, Out-of-Sync, Synchronizing,
Scrambled, Empty, Incomplete, or Local Only)
role whether the current system is the Primary (source) or Secondary (destination) for this group
condition whether the group is functioning (Active), Inactive, Admin Fractured (suspended), Waiting on Sync,
System Fractured (which indicates link down), or Unknown
recovery policy type of recovery policy (Automatic is the default and recommended value for group during backend
configuration; if Manual is set, you must use -resume after a link down failure)
number of mirrors number of mirrors in group
mode MirrorView mode (always SYNC in this release)
owner ACL ID assigned (0 indicates no control). See nas_acl.
mirrored disks comma-separated list of disks that are mirrored
local clarid APM number of local CLARiiON storage array
remote clarid APM number of remote CLARiiON storage array
mirror direction on primary system, local to remote (on primary system); on destination system, local from remote
Value Definition
Servers configured
with RDFstandby/
Servers configured
as standby
id server ID
name server name
acl ACL value and owner
type server type (for example, nas or standby)
slot slot number for this Data Mover
member_of If applicable, shows membership information
standby If this Data Mover is configured with local standbys, the server that is the local standby and any policy
information
To Next Page
Loading...
Need help?
General
