296
Celerra Network Server Command Reference Manual
The server Commands
-disconnect <mgfs> {-path <localpath>|-path <cid>|-all}
Removes a connection without migrating the data. The <localpath> is
not removed nor is any partially migrated data.
The administrator should manually remove this data before
attempting a -verify or -Convert command. It may require the
administrator to handle a partial migration of old data as well as
potentially new data created by users.
EMC recommends not to use the -disconnect command if the
administrator has exported this directory for user access.
-verify <mgfs>
Checks that all data has completed the migration for the <mgfs>.
[-path {<localpath>|<cid>}]
If the -path option is provided, it can check on a communication
basis. If no path is provided, the system defaults to checking all
connections on the file system.
-Convert <mgfs>
Performs a verify check on the entire file system, then changes the file
system type from MGFS to UxFS. After the -Convert command
succeeds, no data migration can be done on that file system.
-start <mgfs> -path <localpath> [-Force] -log <logpath>
Directs the Data Mover to migrate all files from the source file server
to the Celerra Network Server. The -log option provides detailed
information on the state of the migration, and any failures that might
occur. The <localpath> is the path where the migration thread is
started. The -Force option is used if you need to start a migration
thread a second time on the same <localpath> where a previous
migration thread had already finished. For example, -Force would be
needed to start a thread which had no include file (that is, to migrate
all remaining files) on <localpath> where a thread with an include
file had already been run.
[-include <include_path>]
Starts the thread in the <include_path> which is the path of the
file containing the specified directories.
[-exclude <exclude_path>]
Excludes files or directories from migration. The <include_path>
is the path of the file containing the specified directories.
-halt <mgfs> -path <localpath>
Stops a running thread, and halts its execution on the Data Mover.
To Next Page
Loading...
Need help?
General
