EMC Celerra User Manual

392
Celerra Network Server Command Reference Manual
The server Commands
EXAMPLE #4 To configure the use of simple authentication by specifying a bind
DN (Distinguished Name) and password, type:
$ server_ldap server_2 -set -p -domain nasdocs.emc.com -servers 172.16.21.10
-binddn name
server_2 : Enter Password:*******
done
EXAMPLE #5 To delete the LDAP configuration for the specified Data Mover and
stop the service, type:
$ server_ldap server_2 -clear
server_2 : done
EXAMPLE #6 To display informaton about the iPlanet configuration on a Data
Mover, type:
$ server_ldap server_2 -info
server_2 :
LDAP domain: nasdocs.emc.com
State: Configured - Connected
NIS domain: nasdocs
Proxy (Bind) DN: name
Profile Name: celerra_profile
Profile TTL: 60 seconds
Connected to LDAP server address: 172.16.21.10 - port 389
Where:
EXAMPLE #7 To start the iPlanet service, type:
$ server_ldap server_2 -service -start
server_2 : done
EXAMPLE #8 To provide information about a user, type:
$ server_ldap server_2 -lookup -user luser1
server_2 :
user: luser1, uid: 501, gid: 500, gecos: luser one, home dir: /home/luser1, shell:
/bin/bash
Value Definition
LDAP domain iPlanet domain name.
State status of the iPlanet service.
NIS domain NIS domain name.
Proxy (Bind) DN DN (distinguished name) of the ID.
Profile Name name of the client configuration profile.
Profile TTL how often the Celerra Network Server checks for configuration profile changes.
Connected to LDAP
server address
IP address and port number of the iPlanet server.

EMC Celerra Specifications

General

Brand	EMC
Model	Celerra
Category	Server
Language	English