To Next Page

To Previous Page

fs_dhsm

The fs Commands

Note: The full migration may take minutes or hours if the file is very

large.

FOR NFS

CONNECTIONS

[{[-nfs_server <address>]

Specifies the name or IP address of the secondary NFS server.

Note: Although an IP address can be specified for the <nfs_server>, EMC

strongly suggests using the hostname of the server, which allows use of

the DNS failover capability.

[-localPort <port>]

Specifies a port to override the default port used by the Data

Mover during connection for compatibility with firewalls.

[-proto {TCP|UDP}]

Specifies the protocol for the Data Mover to use for NFS

communications to the secondary <nfs_server>. TCP is the

default.

[-useRootCred {true|false}]}

Specifies the user credentials that the Data Mover uses when

requesting data from the secondary Celerra Network Server.

When set to true, the Data Mover requests data as the root

user (UID 0), when set to false (default) the Data Mover

requests data as the owner of the file as specified in the stub

file.

Note: If the -useRootCred option is set to true, the secondary storage

NFS server must grant the Data Mover root privilege for NFS traffic.

FOR CIFS

CONNECTIONS

{[-cifs_server <fqdn>]

Specifies the fully qualified domain name of the secondary CIFS

server.

[-local_server <host_name>]

Specifies the NetBIOS name or computer name of the local

CIFS server on the Data Mover.

[-password <password>]

Allows the user to specify the admin password. The password

is not recorded in the command log. If the -password option is

given but no password is specified, the user is prompted

interactively.

EMC Celerra User Manual

Other manuals for EMC Celerra