EMC Celerra

496
Celerra Network Server Command Reference Manual
The server Commands
EXAMPLE #17 To display information for drive 0 on VTLU 3, type:
$ server_vtlu server_2 -drive -info 0 -tlu 3
server_2 :
id = 0
device_name = c1t0l1
serial_number = NXB2w4W000
status = empty
tape_barcode =
EXAMPLE #18 To delete storage from VTLU 3, type:
$ server_vtlu server_2 -storage -delete ufs1 -tlu 3
server_2 : done
EXAMPLE #19 To delete VTLU 3 from server_2, type:
$ server_vtlu server_2 -tlu -delete 3
server_2 : done
serial_number the VTLU serial number that is automatically assigned.
status status of the virtual tape drive; possible values are empty, loaded, and in use.
tape_barcode barcode of the virtual tape if status is not empty.