EMC Celerra - Page 84

84
Celerra Network Server Command Reference Manual
The fs Commands
Where:
Where:
EXAMPLE #3 To abort replication on the source side of the replication relationship,
from the source Control Station type:
$ fs_replicate -abort src_ufs1
operation in progress (not interruptible)...id = 58
name = src_ufs1
acl = 0
in_use = True
type = uxfs
worm = off
volume = v156
pool = clar_r5_performance
member_of = root_avm_fs_group_3
rw_servers= server_2
ro_servers=
rw_vdms =
ro_vdms =
ckpts = src_ufs1_ckpt1
ip_copies = dst_ufs1:cs110
stor_devs = APM00042000818-0014,APM00042000818-001B,APM00042000818-0018,APM00042
000818-0017
disks = d21,d12,d19,d10
disk=d21 stor_dev=APM00042000818-0014 addr=c16t0l15 server=server_2
disk=d21 stor_dev=APM00042000818-0014 addr=c48t0l15 server=server_2
disk=d21 stor_dev=APM00042000818-0014 addr=c0t0l15 server=server_2
Value For the Communication between Celerras Definition
communication_state whether the Data Movers on each Celerra system can communicate with each other.
current_transfer_rate rate at which the last 128 MB of data was sent across the IP network.
avg_transfer_rate average rate at which the last 128 sets of data were sent across the IP network.
source_ip IP address of the source Data Mover.
source_port port number of the source Data Mover that is assigned dynamically.
destination_ip IP address of the destination Data Mover.
destination_port port number of the destination Data Mover. This is always assigned the number 8888 by default.
QOS_bandwidth IP network bandwidth throttle that can be used for this replication relationship. Zero (0) represents
unlimited bandwidth.
Value For the Verbose option Definition
Source File System:
Delta delta set number or delta set ID that was created.
Create Time date and start time the delta set was created.
Dur duration of time (in seconds) that it took to create the delta set.
Blocks number of blocks modified in the delta set.
Destination File System:
Playback Time date and start time the delta set was replayed to the destination file system.
Dur duration of time (in seconds) that it took to replay the delta set or DSiG.
Blocks number of blocks modified in the delta set.
DSiG number of delta sets in the group that were played back. In some instances, the playback service
can play back more than one delta set at a time. In this case, the Dur and Blocks fields refer to the
group as a whole, not an individual delta set.