Inspection and Unpacking
17 Liebert
®
CRV
™
Figure 10 Removing the 600mm (24") unit from the skid
3.6 Reattaching the Baffle Panel—600mm (24") Units
Once the Liebert CRV has been moved to where it will be installed, the baffle panel can be reattached.
1. Open top panel door (the one with the Liebert iCOM
®
).
2. Reattach the bottom baffle panel assembly with screws, using a T30 Torx drive.
3. Close and latch top panel door.
4 Bolts on Each Side
Secure the Tie-Down
Bracket to the Skid
M17 Socket
M13 Socket
Step 5
197023
Rev. 5
Step 1
Step 8
Step 8
Step 15
To Next Page
Loading...
