Liebert iCOM
®
Control
83 Liebert
®
CRV
™
Service Menus
The Service menu contains settings and features used to set up unit communication and for unit
maintenance. Figure 55 below provides an overview of the menu.
Figure 55 Service menu icons
NOTE
The Liebert iCOM control has three main menus: User, Service and Advanced. Menu settings
may be viewed without a password, but changing settings requires a password. If a password
is required, Liebert iCOM shows a prompt to enter the password. The password for the User
menu is 1490. The password for the Service menu is 5010.
See 11.3.1 Entering a Password for entering password.
Table 32 Service menu icons
Icon Name
Description
Setpoints
To view and
change
temperature and
humidity setpoints
Unit Diary
Shows all entered
program changes
and maintenance
performed on the
unit.
Standby Settings/
Lead-Lag
Allows lead/lag
setup when
multiple units are
connected
Maintenance/
Wellness Settings
Allows setting
maintenance
interval reminder,
maintenance
message, number
of unit starts and
stops and time
since last
maintenance
Diagnostics/
Service Mode
Allows
troubleshooting,
manual mode,
read analog and
digital inputs
Set Alarms
Allows enable,
disable and
settings for
alarms
Sensor
Calibration/
Setup
Allows calibration
of sensors
System/Network
Setup
Allows setup and
U2U communication
for multiple units
Options Setup
Allows setup of
component
operation
Rack Setup
Label racks,
establish settings
for sensors
Service
Contact Info
Contains key
contact
information for
local service,
including names
and phone
numbers
Humidifier
Settings
Change
Humidifier
settings
NOTE
Menu settings may be viewed without a password, but changing settings requires a password.
If a password is required, the Liebert iCOM shows a prompt to enter the password. The
password for the User menu is 1490. The password for the Service menu is 5010. For details on
entering a password, see 11.3.1 Entering a Password.
Service Menu
password: 5010
To Next Page
Loading...
