Emerson Liebert CRV - 10.4.2 Adjust Baffles on 300 Mm (12) Models; Figure 51 Adjust the Baffles to Ensure Correct Airflow Direction-300 Mm (24) Models

Startup
Liebert
®
CRV
™
78
10.4.2 Adjust Baffles on 300mm (12") Models
To adjust the baffles on 300mm (12") models:
1. Shut down the Liebert CRV.
2. Open the door containing the Liebert iCOM
®
display.
3. Remove the screws that secure the baffle panel in place.
Each panel is secured with four screws, two on each side.
4. Slide out the baffle panel.
5. Rotate the baffle panel around its horizontal axis to change the airflow direction.
6. Reinsert the baffle panel.
7. Repeat for all baffles to be changed.
8. Reinstall the screws in the metal brace.
Figure 51 Adjust the baffles to ensure correct airflow direction—300mm (24") models
NOTE
The air baffles on 300mm (12") units may be changed to direct air either right or left.
B
DPN002809
Rev. 1
Inside View
Remove screws, rotate baffles to desired
airflow direction. Reinstall screws.
Open
Door
Each arrow represents
a baffle segment. Unit
ships with baffles pointing
in alternating directions.
Step 3
Step 4
Step 5
Step 6