Postrequisites
If you disabled LD Optimization before the calibration procedure, re-enable it.
12.6.3 Perform a D1 and D2 density calibration using the Field
Communicator
Procedure
1. Read the Prerequisites in Perform a (standard) D1 and D2 density calibration if you have not already
done so.
2. See the following figure.
Postrequisites
If you disabled LD Optimization before the calibration procedure, re-enable it.
Configuration and Use Manual Measurement support
MMI-20048166 April 2019
Configuration and Use Manual 143
To Next Page
Loading...
