• Range: 0 to 5
Tip
The lower the precision, the greater the change must be for it to be reflected on the display. Do not set
Number of Decimal Places too low to be useful.
7.1.4 Turn on and turn off automatic scrolling through the display
variables
Display Menu > Configuration > Display Settings > Auto Scroll
ProLink III Device Tools > Configuration > Transmitter Display > General > Auto Scroll
Field Communicator Configure > Manual Setup > Display > Display Behavior > Auto Scroll
You can configure the display to automatically scroll through the list of display variables or to show a single
display variable until the operator activates Scroll. If Auto Scroll is turned on, you can configure the number
of seconds that each display variable will be shown.
Procedure
1. Turn on or turn off Auto Scroll as desired.
Option Description
On The display automatically shows each display variable for the number of seconds specified
by Scroll Rate, then shows the next display variable. The operator can move to the next
display variable at any time by activating Scroll.
Off The display shows Display Variable 1 and does not scroll automatically. The operator can
move to the next display variable at any time by activating Scroll.
• Default: Off
2. If you turned on Auto Scroll, set Scroll Rate as desired.
• Default: 10
• Range: 1 to 30 seconds
Tip
Scroll Rate may not be available until you apply Auto Scroll.
7.1.5 Configure the display backlight
Display
Menu > Configuration > Display Settings > Backlight
ProLink III Device Tools > Configuration > Transmitter Display > General > Backlight
Field Communicator Configure > Manual Setup > Display > Backlight
You can set the backlight on the display's LCD panel to either ON or OFF. You can also set Contrast as desired
(Default: 70).
Configuration and Use Manual Configure device options and preferences
MMI-20048166 April 2019
Configuration and Use Manual 83
To Next Page
Loading...
