Alert number Alert title Default severity User can reset
severity
A120 Curve Fit Failure (Concentration) Informational No
A132 Sensor Simulation Active Informational Yes
A133 EEPROM Error (Display) Informational Yes
A136 Incorrect Display Type Informational Yes
9.5 Configure informational parameters
ProLink III Device Tools → Configuration → Meter Information
Field communicator Configure → Manual Setup → Info Parameters
The informational parameters can be used to identify or describe your meter. They are not used in process
measurement and they are not required.
Procedure
Enter data as desired.
Parameter Description
Meter Serial
Number
The serial number of the device. Enter the value from the device tag.
Message
A message to be stored in device memory. The message can contain up to
32 characters.
Descriptor
A description of this device. The description can contain up to 16 characters.
Date
A static date (not updated by the meter). Enter the date in the form mm/dd/yyyy.
Flange Type
The sensor flange type for this device. Obtain the value from the documents shipped
with the device or from a code in the model number.
Tip
• A field communicator will not support all informational parameters. If you need to configure all of the
informational parameters, use ProLink III.
• A field communicator will allow you to configure HART Tag and HART Long Tag from this location. These
parameters are replicated from Configure → Manual Setup → HART → Communications. These
parameters are used in HART communications.
Configuration and Use Manual Configure device options and preferences
MMI-20020954 March 2021
Configuration and Use Manual 83
To Next Page
Loading...
