Emerson PACSystems SLM042 User Manual

PACSystems Ethernet Switch SLM042 User Manual Section 5
GFK-3123A Jan 2020
Web Management 14
5.2.2 IP configuration
You can configure the IP Settings and DHCP client function through IP configuration.
Figure 9: IP Configuration
The following table describes the labels in this screen.
Label
Description
DHCP Client
To enable or disable the DHCP client function. When DHCP client
function is enabling, the switch will assign the IP address from the
network DHCP server. The default IP address will be replaced by
the IP address which the DHCP server has assigned. After clicking
“Apply” button, a popup dialog will show up to inform you when
the DHCP client is enabling. The current IP will lose and you should
find the new IP on the DHCP server.
IP Address
Assign the IP address that the network is using. If DHCP client
function is enabling, you do not need to assign the IP address. The
network DHCP server will assign the IP address for the switch and it
will be displayed in this column. The default IP is 192.168. 0.100
Subnet Mask
Assign the subnet mask for the IP address. If DHCP client function is
enabling, you do not need to assign the subnet mask.
Gateway
Assign the network gateway for the switch. The default gateway is
192.168. 0.254
DNS1
Assign the primary DNS IP address
DNS2
Assign the secondary DNS IP address
Apply
Click Apply to activate the configurations.

Emerson PACSystems SLM042 Specifications

General

Brand	Emerson
Model	PACSystems SLM042
Category	Switch
Language	English