4 Device network configuration
In order to communicate with the Wireless Gateway, and ultimately the host
system, the transmitter must be configured to communicate with the
wireless network. This step is the wireless equivalent of connecting wires
from a transmitter to the information system. Using a Field Communicator
or AMS Wireless Configurator, enter the Network ID and Join Key so they
match the Network ID and Join Key of the Gateway and other devices in the
network. If the Network ID and Join Key do not match that of the Gateway,
the Rosemount 702 Transmitter will not communicate with the network.
The Network ID and Join Key may be obtained from the Wireless Gateway on
the Setup Network Settings page on the web interface, shown in Figure 4-1.
Figure 4-1: Gateway Network Settings
4.1 AMS Wireless Configurator
Procedure
1. Right click on the Rosemount 702 Transmitter.
2. Select Configure.
3. When the menu opens, select Join Device to Network.
4. Follow the method to enter the Network ID and Join Key.
4.2
Field Communicator
The Network ID and Join Key may be changed in the wireless device by using
the following Fast Key sequence. Set both Network ID and Join Key.
Function
Fast Key sequence Menu items
Wireless setup 2,2,1 Network ID, Join Device to
Network
Quick Start Guide April 2021
14 Emerson.com/Rosemount
To Next Page
Loading...
