Emerson Rosemount 702 - 3.2 Remote mount installation

3.2 Remote mount installation
Figure 3-2: Remote Mount
A. Rosemount 702 Transmitter
B. Float switch
Procedure
1. Install the switch according to standard installation practices making
sure to use thread sealant on all connections.
2. Run wiring (and conduit if necessary) from the switch to the
Rosemount 702 Transmitter.
3. Pull the wiring through the threaded conduit entry of the Rosemount
702 Transmitter.
4. Attach the switch wiring to the terminals as indicated on the wiring
diagram (see Reference information: wiring switch inputs, output
circuits, and leak sensors).
5. Connect the power module.
Note
Wireless devices should be powered up in order of proximity from
the Wireless Gateway, beginning with the closest device to the
gateway. This will result in a simpler and faster network formation.
April 2021 Quick Start Guide
Quick Start Guide 9