Why are not all windows shown on my Emotron M20?
If not all windows are shown on your Emotron Protection Device, it may be because when the special functions are used (windows 35, 65 etc.) blocked windows for settings are not shown.
Important notes before proceeding with setup and connection.
Steps for connecting the unit and initial setup before powering on.
Guide on how to start the motor/machine for the first time.
Setting maximum and minimum alarm levels manually.
Setting alarm levels based on maximum/minimum loads and approximate calculations.
Wiring diagram for three-phase motor connections.
Wiring diagram for single-phase motor connections.
Example of wiring digital inputs to the unit.
Guide to selecting the correct current transformer for motors below 100 A.
Guide to selecting current transformers for motors above 100 A.
General overview of the unit's operation and display elements.
Explanation of the different windows and their functions.
Step-by-step instructions on modifying parameter values in the unit.
How to select the unit of measurement for power and current.
Configuring the motor's rated power and current values.
Configuring the number of phases for the motor connection.
Setting monitor functions, alarm levels, and start delay parameters.
Defining the delay period for motor startup to avoid false alarms.
Automatically setting alarm levels based on measured motor load.
Configuring delay times before alarm relays are activated.
Manually configuring alarm levels, margins, hysteresis, and digital input.
Configuring relay outputs, block timer, and analogue output signals.
Setting analogue output range and locking parameters to prevent changes.
Resetting to factory defaults and viewing alarm messages.
Configuring special functions like separate relays and reverse operation.
General| Communication | Modbus RTU |
|---|---|
| Protection class | IP20 |
| Mounting | DIN rail |
| Type | Motor protection |
| Power consumption | 5 W |
| Analogue output | 4-20 mA or 0-20 mA |
| Rated voltage | 690 V AC |
To Next Page
