4 Connectors Description
4.1 12 V External Power (J1701)
This connector is used to supply the main VCC input voltage.
Apply only 12 V DC to this connector.
Pin Number Signal Name Description
1 (inner) VCC_MAIN_IN 12 V DC (nominal) input voltage
2 (outer) GND Ground
Table 6: J1701 - External Power Connector
Type Manufacturer
PJ-102AH CUI
Table 7: J1701 - External Power Connector Type
4.2 12 V Internal Power (J1700)
The Mercury+ ST1 base board base board can alternatively be powered through the internal power input
connector J1700. The 12 V DC power source connected to J1700 must be filtered by external power circuitry.
Apply only 12 V DC to this connector.
Pin Number Signal Name Description
1 VCC_MAIN 12 V DC (nominal) input voltage
2 GND Ground
Table 8: J1700 - Internal Power Connector
Type Manufacturer
292132-2 TE Connectivity
Table 9: J1700 - Internal Power Connector Type
Warning!
Do not short circuit the 12 V power supply, and make sure the currents flowing through the pins of this
connector do not exceed 2.0 A. Otherwise, the PCB may be damaged.
D-0000-456-001 18 / 48 Version 02, 23.07.2020
To Next Page
Loading...
Need help?
General