1 Overview
1.1 General
1.1.1 Introduction
The Mercury+ ST1 base board is equipped with a multitude of I/O connectors for use with Mercury family
FPGA and SoC modules. The board is well-suited for rapid prototyping and for building FPGA systems,
without the need for developing custom hardware.
The board can also be used for production flash programming on Mercury modules, or for educational
purposes.
This board is specially designed for image processing applications.
The main features of the Mercury+ ST1 base board are:
• Support for USB 3.0 host and USB 3.0 device
• FTDI USB 2.0 High-Speed device controller
• High-speed FPGA and flash programming over USB
• FMC HPC Connector
• Versatile set of I/O connectivity options
• 2 × Ethernet RJ45 connectors
• SFP+ connector
• 2 × MIPI D-PHY interfaces (CSI , CSI/DSI)
• HDMI 2.0a connector
• Mini DisplayPort connector
• Low-jitter clock generator
• microSD card slot
• Simple integration by using a single 12 V voltage supply
• Small solution size
1.1.2 Warranty
Please refer to the General Business Conditions, available on the Enclustra website [1].
1.1.3 RoHS
The Mercury+ ST1 base board is designed and produced according to the Restriction of Hazardous Sub-
stances (RoHS) Directive (2011/65/EC).
1.1.4 Disposal and WEEE
The Mercury+ ST1 base board must be properly disposed of at the end of its life. If a battery is installed on
the board, it must also be properly disposed of.
The Waste Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) is not applicable for the Mer-
cury+ ST1 base board.
1.1.5 Safety Recommendations and Warnings
Mercury boards are not designed to be “ready for operation” for the end-user. Proper configuration of the
hardware before usage is required.
D-0000-456-001 5 / 48 Version 02, 23.07.2020
To Next Page
Loading...
Need help?
General