A Appendix
Use Module USB USB USB USB-B USB-A USB USB PS MGT2 SS PS MGT3 SS FX3 SS
Scenario MODE1 MODE0 HS1_OE# HS0 HS1 USB0 USB1
e.g. DIP Switch DIP Switch Logic seen from seen from seen from seen from seen from seen from seen from
connector connector module module module module module
1A) Single HS USB
1
ZX1
1B) Single HS USB
2
ZX5 On On 0
3
- USB-HS0 USB-A VBUS USB-A - -
as host SA1
2) Single HS USB KX1
Module using USB-B KX2 On Off 0 USB-HS0 - USB-B VBUS USB-A - USB-B
(option with FX3) CA1
3) Dual HS USB XU1
Module (option XU5, XU7 Off On 0 USB-HS0 USB-HS1 USB-B USB-A USB-B USB-A -
with PS SS0 and SS1) XU8, XU9
4) Dual HS USB AA1
Module using USB-B SA2 Off Off 0 USB-HS0 USB-HS1 USB-B USB-A - - USB-B
(option with FX3)
Table 35: USB Use Case Scenario
1
Single HS USB Module, without SS, using USB-A
2
XU1 with HS1 not active and HS0/PS SS USB0 as host using USB-A
3
Solder option resistors R703 (DNE), R704 default = 0 (use case 1A and 1B ”out-of-specification” by connecting unused USB DP to 5V)
D-0000-456-001 48 / 48 Version 02, 23.07.2020
To Previous Page
Loading...
Need help?
General