6.5 USB
6.5.1 USB Overview
Figure 12 presents an overview of the USB connections on the Mercury+ ST1 base board.
Figure 12: USB Connections Overview
Table 25 describes the connectivity options for USB on the Mercury+ ST1 base board. The default configu-
ration is marked in bold.
USB 3.0 support is possible when the Mercury module is equipped with a Cypress FX3 USB 3.0 device con-
troller or when the module is equipped with a Zynq Ultrascale+ device with USB 3.0 support on the PS GTR
D-0000-456-001 34 / 48 Version 02, 23.07.2020
To Next Page
Loading...