Specifications qTOWER iris
34
11.3 Standards and directives
Protection class and protection
type
The device is protection class I. The housing is protection type IP 20.
Overvoltage category
The device has overvoltage category II according to DIN60664-1.
Device safety
The device complies with the following safety standards
¡ EN 61010-1
¡ EN 61010-2-081
¡ EN 61010-2-010
EMC compatibility
The device has been checked for transient emissions and noise immunity.
It meets the requirements for transient emissions according to
¡ EN 61326-1 (EN 55011 group1, classB)
The device meets the requirements for noise immunity according to
¡ EN 61326-1 (requirements for use in a basic environment)
US regulations
The device meets the requirements of Part 15 of the FCC regulations (Federal Communi-
cations Commission Advisory). The following two requirements pertain to operation: (1)
The device does not cause interference, and (2) the device is resistant to interference,
including such interference as is liable to cause malfunctions. The device meets the re-
quirements of Part 18 of the FCC regulations.
Canada regulations
The device meets the requirements of Canadian industry standard ICES-001 (Interfer-
ence-Causing Equipment Standard).
Guidelines for China
The device contains substances subject to regulation (according to the directive GB/T
26572-2011). Analytik Jena guarantees that, if the device is used as intended, these
substances will not leak within the next 25 years and therefore will not pose a threat to
the environment or health within this time period.
EU directives
The device meets the requirements of the directive 2011/65/EU.
The device is designed and tested in accordance with standards meeting the require-
ments of EU directives 2014/35/EU and 2014/30/EU. The device leaves the factory in a
sound condition with regard to technical safety. To maintain this condition and to en-
sure safe operation, the user must strictly observe the safety and operating instructions
contained in this operating manual. For accessories delivered with the device and sys-
tem components from other manufacturers, the information provided in their respective
operating manuals has priority.
To Next Page
Loading...
