qTOWER iris Security
9
Hazard from substances
The device can be used to handle hazardous substances. The operator is responsible for
the safe handling of these substances.
¡ If the device has been contaminated with hazardous substances, decontaminate it
as described in the operating manual. Use other methods only after consultation
with Analytik Jena.
¡ Do not apply oil between samples and sample block. Oil can cause harmful vapors to
form.
3.5 Safety instructions for maintenance and cleaning
There is a risk of electric shock if contact is made with live components, which may lead
to serious injury.
Unauthorized servicing can lead to maladjustment or damage of the device and its sys-
tem components.
¡ Work on electrical components inside the device may be carried out by customer
service only.
¡ Only carry out the maintenance actions listed in the operating manual.
¡ Switch off the device before maintenance and cleaning. Only work on a switched-on
device if this is expressly required by the operating manual.
¡ Use only original spare parts, wear parts and consumables. These have been tested
and ensure safe operation.
¡ After maintenance, ensure that all safety devices are fully functional again.
¡ Clean the device with a damp, non-dripping cloth. Do not use organic solvents, abra-
sive cleaners or bleach.
3.6 Behavior during emergencies
In an emergency such as a laboratory fire, live devices put rescue personnel at risk.
¡ If possible, switch off the device and its components at the power switch and discon-
nect the power cable from the mains socket.
To Next Page
Loading...
Need help?
General
