qTOWER iris Security
7
3 Security
For your own safety and to ensure error-free and safe operation of the device, please
read this chapter carefully before commissioning.
Observe all safety instructions listed in this user manual and all messages and informa-
tion displayed on the monitor by the control and analysis software.
3.1 Safety labeling on the device
Warning and mandatory action labels have been attached to the device and must always
be observed. Damaged or missing warning and mandatory action labels can cause incor-
rect actions leading to personal injury or material damage.
¡ Do not remove the warning and mandatory action signs.
¡ Replace damaged signs.
The following warning and mandatory action signs are used:
Warning/mandatory sign Meaning
Disconnect the power supply before opening the device
cover.
The device contains controlled substances. Analytik Jena
warrants that these substances will not be released from
the device within the next 25years provided the device is
employed as intended.
General warning sign
Warning against hot surface
3.2 Requirements for the operating personnel
The device must only be operated by qualified specialist personnel instructed in the use
of the device. The operating personnel must meet the following requirements:
¡ Operate the device only after instruction and training.
¡ Know and avoid dangers when working with the device.
¡ Wear personal protective equipment such as protective gloves, lab coat and safety
goggles.
¡ Training by Analytik Jena is recommended.
The operator of the device is responsible for compliance with safety and occupational
health regulations. The operator must meet the following requirements:
¡ Provide information about national regulations on work safety and accident preven-
tion and observe them during operation of the device.
¡ Instruct the operating personnel in the safe operation of the device. In doing so, also
convey the contents of the manuals for the device system.
To Next Page
Loading...
