Deltabar S
54 Endress+Hauser
PMD 70 (continued)
50 Calibration, units
1 Calibration: nominal range, mbar/bar
2 Calibration: nominal range, kPa/MPa
3 Calibration: nominal range, mmH
2
O/mH
2
O
4 Calibration: nominal range, in H
2
O/ftH
2
O
6 Calibration: nominal range, psi
B Custom calibration: see additional specification
C Factory calibration: see additional specification, Factory calibration certificate, 5-point
D DKD calibration: see additional specification, DKD-Certificate
K Calibration: see additional specification, PLATINUM
L Factory calibration: see additional specification, PLATINUM,
Factory calibration certificate, 5-point
M DKD calibration: see additional specification. PLATINUM, DKD-Certificate
70 Process connection, material
B 1/4" – 18 NPT IEC 61518, mounting: 7/16" – 20 UNF, C22.8
D 1/4" – 18 NPT IEC 61518, mounting: 7/16" – 20 UNF, AISI 316L
F 1/4 "– 18 NPT IEC 61518, mounting: 7/16" – 20 UNF, Alloy C
G 1/4" – 18 NPT IEC 61518, mounting: 7/16" – 20 UNF, PVDF
U RC 1/4 mounting: 7/1" – 20 UNF, AISI 316L
1 1/4" – 18 NPT, mounting: PN 160: M10, C22.8
2 1/4" – 18 NPT, mounting: PN 160: M10, AISI 316L
3 1/4 "– 18 NPT, mounting: PN 160: M10, Alloy C
80 Gasket material
A FKM Viton cell seal
B EPDM cell seal
D Kalrez cell seal
E Chemraz cell seal
1 FKM Viton cell seal, degreased
2 FKM Viton seal, cleaned for oxygen service
100 Additional options 1
A Additional options 1 not selected
B Material test certificate for wetted components, inspection certificate as per EN
10204 3.1.B acc. to specification 52005759
M Overvoltage protection
NHistoROM module
S GL (German Lloyd) marine certificate
V Mounting on shut-off valve from above
W Mounting on shut-off valve from below
2 Test report acc. to EN10204 2.2
3 Routine test with certificate, inspection certificate as per EN 10204 3.1.B
4 Overpressure test with certificate,
inspection certificate as per EN 10204 3.1.B
110 Additional options 2
A Additional options 2 not selected
K Vent valves (2 pieces), Alloy C
M Overvoltage protection
NHistoROM module
R Screws 7/16" UNF, length 1-1/2" (4 pieces)
S GL (German Lloyd) marine certificate
U Mounting bracket for wall and pipe, AISI 316L
2 Test report acc. to EN10204 2.2
3 Routine test with certificate, inspection certificate as per EN 10204 3.1.B
4 Overpressure test with certificate,
inspection certificate as per EN 10204 3.1.B
5 Helium leak test EN 1518 with test certificate,
inspection certificate as per EN 10204 3.1.B
PMD 70 complete order code
To Next Page
Loading...
