Deltabar S
Endress+Hauser 9
Human interface
Display module (optional) A 4-line liquid crystal display (LCD) is used for display and operation. The display module shows measured
values, dialog text as well as fault and notice messages in plain text, thereby supporting the user in every stage
of operation.
Functions:
• 8-digit measured value display including sign and decimal point, bargraph for current display
• Simple and complete menu guidance due to separation of the parameters into three levels (blocks, groups
and functions)
• Each parameter is given a 3-digit ID number for easy navigation.
• Option for configuring the display according to individual requirements and desires, such as language,
alternating display, display of other measured values such as sensor temperature, contrast setting
• Comprehensive diagnostic functions (fault and warning message, peak-hold indicators, etc.)
• 4 to 20 mA HART: rapid and safe commissioning with the Quick Setup menus
P01-xMD7xxxx-07-xx-xx-xx-000
Operating elements The operating buttons are located either under the protective cap on the exterior of the device or inside on the
electronic insert, depending on configuration of transmitter.
Operating buttons on the exterior of the device
P01-xxxxxxxx-19-xx-xx-xx-038
Measured value display
Editing modes
Function name Value
Identification
number
Header line
Main line
Information
line
Symbol
Bargraph
Unit
Selection
option
Edit value
Current measured value
To Next Page
Loading...
