Endress+Hauser Deltabar S PMD75 - Page 207

Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 207
Table 34: OPERATING MENU → DIAGNOSTICS → MESSAGES
Parameter name Description
ALARM STATUS (046)
Display
Displays the current message present. → See also these Operating Instructions,
Section 12.1 "Messages" and Section 12.3 "Confirming messages".
Local operation
• The measured value display shows the message with the highest priority.
• The ALARM STATUS parameter shows all the messages in descending order of
priority. You can scroll through all the messages present with the O or S key.
FieldCare
• The ALARM STATUS parameter shows the message with the highest priority.
LAST DIAG. CODE (564)
Display
Displays the last message that occurred and was eliminated.
!
Note!
• Local operation: you can scroll through the last 15 messages with the O or S key.
• FieldCare: the last message appears on the display.
• Use the RESET ALL ALARMS parameter to delete the messages listed in the LAST
DIAG. CODE parameter.
ACK. ALARM MODE (401)
Selection
Switch on the acknowledge alarm mode.
→ See also ACK. ALARM.
Options:
•On
•Off
Factory setting:
Off
ACK. ALARM (500)
Selection
Acknowledge the alarm.
Prerequisite:
• ACK. ALARM MODE = On
Options:
• Abort
•Confirm
The cause of the alarm must be eliminated, the message must be acknowledged via the
ACK. ALARM parameter and, where applicable, the ALARM DISPL. TIME (→ ä 208)
has to have elapsed before the device starts measuring again following an alarm.
→ See also these Operating Instructions, Section 12.3 "Confirming messages".
Factory setting:
Abort
RESET ALL ALARMS (603)
Selection
Use this parameter to reset all the alarms of the LAST DIAG. CODE parameter.
Options:
• Abort
•Confirm
Factory setting:
Abort
ERROR No.
Entry
For "Error"-type messages, you can decide whether the device should behave as in the
event of an alarm (A) or as in the event of a warning (W). Enter the corresponding
message number for this parameter. → See also SELECT ALARMTYPE.
→ See also these Operating Instructions, Section 12.1 "Messages" and Section 12.2
"Response of outputs to errors".