Notes on use Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus
6 Endress+Hauser
1 Notes on use
Sections 4 to 6 describe how to operate the unit using an FF configuration program.
With FOUNDATION Fieldbus, all the device parameters are categorized according to their
functional properties and task and are assigned to the Resource Block, the Transducer Blocks and
the function blocks. The parameters of the Resource Block, the Transducer Blocks and the Analog
Input Block are described in Section 7. For a description of the parameters of the other function
blocks, such as the PID or Discret Ouput Block, see Operating Instructions BA00013S
"FOUNDATION Fieldbus Overview" or the FOUNDATION Fieldbus Specification.
Sections 8 to 10 describe how to operate the unit via the local operation and the Endress+Hauser
operating program FieldCare.
Section 11 describes all the parameters in the order of how they appear in the menu.
Sections 1.1 and 1.2 describe ways of finding a certain parameter description more easily.
1.1 Finding parameter descriptions using ID numbers
Each parameter is indicated on the local operation with a unique identification number (ID). All the
parameters are listed in numerical order in Section 2. The page reference/link takes you to the
parameter in question.
In FieldCare, additional parameters and, to an extent, other parameters are displayed. These
parameters are not listed in Section 2. You can find these parameters by means of the index.
→ See also Section 1.3.
1.2 Finding function groups using graphic representation
All the function groups are shown in table form in Section 3. The page reference/link takes you to
the function group in question. In Section 7, all the parameters of a function group are compiled in
a table.
1.3 Finding parameter descriptions using parameter names
(index)
The index lists all the parameters in alphabetical order. The page reference/link takes you to the
parameter in question.
To Next Page
Loading...
Need help?
General
