Pressure measurement (via local operation and FieldCare) Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus
104 Endress+Hauser
8 Pressure measurement (via local operation and
FieldCare)
!
Note!
• The Cerabar S and the Deltabar S are configured for the pressure measuring mode as standard.
The Deltapilot S is configured for the level measuring mode as standard. The measuring range and
the unit in which the measured value is transmitted, as well as the digital output value of the
Analog Input Block OUT, correspond to the data on the nameplate.
• See also Operating Instructions for Deltabar S (BA00301P) "Pressure measurement" section,
Cerabar S (BA00302P), "Pressure measurement" section or Deltapilot S (BA00372P), "Level
measurement" section.
• For a description of the parameters mentioned, see
– → ä 134, Table 2: GROUP SELECTION → MEASURING MODE
– → ä 142, Table 6: OPERATING MENU → SETTINGS → POSITION ADJUSTMENT
– → ä 144, Table 7: OPERATING MENU → SETTINGS → BASIC SETUP "Pressure".
• For a description of further relevant parameters, see
– → ä 183, Table 15: OPERATING MENU → SETTINGS → EXTENDED SETUP "Pressure"
– → ä 200, Table 27: OPERATING MENU → PROCESSINFO → PROCESS VALUES
"Pressure".
!
Note!
• You can also specify a customer-specific unit. See parameter description for PRESS. ENG. UNIT
(060) (→ ä 144).
To Next Page
Loading...
