Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 133
11 Parameter description (Local operation and
FieldCare)
!
Note!
• The following tables list all the parameters as per the menu structure. Each table corresponds to
a function group in the menu tree. The overall menu structure is illustrated in Section 13.1.
• The menu structure for local operation and FieldCare are slightly different. The differences mainly
affect the MEASURING MODE and LANGUAGE parameters and the LINEARIZATION function
group.
• In FieldCare, additional parameters are displayed. These parameters are marked accordingly.
• The menu path is indicated in the header of each table. You can use this path to get to the
parameters in question.
• The menu has a different structure depending on the measuring mode selected. This means that
some function groups are only displayed for one measuring mode, e.g. the "LINEARIZATION"
function group for the "Level" measuring mode. If certain requirements have to be met for a
function group, these are listed in the first row of the table.
• Some parameters are only displayed if other parameters are appropriately configured. For
example, the EMPTY CALIB. parameter is not displayed in the Quick Setup menu ("Level"
measuring mode) unless the "Linear" option was selected for the LEVEL MODE parameter and
the "Wet" option was selected for the CALIBRATION MODE parameter. There is a comment in
the parameter description here stating: Note: prerequisite: LEVEL MODE = Linear and
CALIBRATION MODE = Wet.
• Parameter names are written in upper case in the text.
• In the "Parameter name" column, the unique identification number (ID) of the parameter is
indicated in brackets. This ID only appears on the local operation.
P01-xxxxxxxx-19-xx-xx-en-079
Fig. 35: 1st selection level in menu, LANGUAGE (→ ä 133, Table 1: GROUP SELECTION → LANGUAGE – Local
operation) and MEASURING MODE (→ ä 134, Table 2: GROUP SELECTION → MEASURING MODE)
1
1
1
2
1) Displayvia on-site display only
2) Displayvia digital communication
Pressure
Level
Flow
OPERATING MENU
Measured value
GROUP SELECTION
LANGUAGE MEASURING MODE
QUICK SETUP
MEASURING MODE
Table 1: GROUP SELECTION → LANGUAGE – Local operation
Parameter name Description
LANGUAGE (079)
Selection
Select the menu language for the local operation.
!
Note!
• In FieldCare, the LANGUAGE parameter is arranged in the DISPLAY function group.
• Select the menu language for FieldCare using the "Language button" in the
configuration window. Select the menu language for the FieldCare frame via the
"Extra" menu → "Options" → "Display" → "Language".
Options:
•Deutsch
• English
• Français
•Español
• Chinese (CHS)
• Japanese (JPN)
Factory setting:
English
To Next Page
Loading...
