Endress+Hauser Deltabar S PMD75 - Page 224

Appendix Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus
224 Endress+Hauser
P01-xxxxxxxx-19-xx-xx-en-149
*
*
B
A
X
*
*
2)
B B BB
A
*
*
*
*
*
*
*
2)
Service
LEVEL SELECTION
CUSTOMER UNIT P
CUST. UNIT FACT. P
CUSTOMER UNIT P
CUST. UNIT FACT. P
PRESS. ENG. UNIT
CUSTOMER UNIT P
CUST. UNIT FACT. P
HEIGHT UNIT
OUTPUT UNIT
CALIBRATION MODE
OUTPUT UNIT
FULL CALIB.
FULL HEIGHT
DAMPING VALUE
EMPTYCALIB.
FULL CALIB.
ADJUST DENSITY
Wet
Dry
DAMPING VALUE
Dry
Wet
EMPTYCALIB.
EMPTY HEIGHT
DENSITYUNIT
ADJUST DENSITY
DENSITYUNIT
CALIBRATION MODE
EMPTYCALIB.
EMPTY PRESSUE
FULL CALIB.
FULL PRESSURE
FULL CALIB.
EMPTYCALIB.
Level Standard
Level Easy Pressure
Level Easy Height
Mass
MASS FLOW UNIT
Vol.
norm cond.
Volume
p. cond.
NORM FLOW UNIT
Vol.
std. cond.
STD. FLOW UNITUNIT FLOW
FLOW-MEAS.TYPE
CUSTOMER UNIT F
MAX. FLOW
CUST. UNIT FACT. F
MAX PRESS. FLOW
DAMPING VALUE
Flow
Continuation,
see the following page
Pressure Level
DAMPING VALUE
BASIC SETUP
PRESS. ENG. UNIT
CUSTOMER UNIT P
CUST. UNIT FACT. P
MEASURING MODE
2) Display via FieldCare
There are parameters that are only displayed if other parameters are
appropriately configured.
For example the Customer Unit P/CUSTOMER_UNIT_PRESSURE parameter is only displayed
if the "User unit" option was selected for the Press. Eng.
Unit/PRESSURE_UNIT parameter.
These parameters are indicated with a "*".