*
*
*
*
* *
*
EDITOR TABLE
LIN. EDIT MODE
Editor Table
Measuring
Table
LINE-NUMB
ADJUST DENSITIY
EDITOR TABLE
EDITOR TABLE
MEASURING TABLE
Editor Table
Measuring
Table
Display via FieldCare
only
Display via on-site
display only
EXTENDED SETUP
Pressure
TEMP. ENG UNIT
Level
DENSITIYUNIT
TEMP. ENG UNIT
PROCESS DENSITY
Flow
LOW FLOW CUT-OFF
SET LRV
SET L. FL. CUT-OFF
SET URV
TEMP. ENG UNIT
EDITOR TABLE
TANK CONTENT MIN
TANK CONTENT MAX
TABLE SELECTION
LIN. EDIT MODE MEASURING TABLE
TANK DESCRIPTION
TOTALIZER SETUP
RESET TOTALIZER 1
TOTALIZER 2 UNIT
TOTALIZER 1 UNIT
FACT. U. U. TOTAL.1
NEG. FLOW TOT. 1
TOT.
2 USER UNIT
FACT. U. U. TOTAL. 2
NEG. FLOW TOT. 2
TOT. 1 USER UNIT
LINEARISATION
Level measuring
mode only
Flow measuring
mode only
(Deltabar S only)
X-VAL.
Y-VAL.
LINE-NUMB
ACTIVE LIN. TAB. X
ACTIVE LIN. TAB. Y
TANK DESCRIPTION
LINEARISATION
Level measuring
mode only
TANK CONTENT MIN
TANK CONTENT MAX
TABLE SELECTION
EDITOR TABLE
There are parameters that are only displayed if other parameters are
appropriately configured.
For example the Tot. 1 User Unit/CUSTOMER_UNIT_TOT_1 parameter is only displayed
if the "User unit" option was selected for the Totalizer 1
Unit/TOTALIZER_1_UNIT parameter.
These parameters are indicated with a "*".
To Next Page
Loading...
