Endress+Hauser iTEMP TMT142B - Page 63

iTEMP TMT142B Operating menu and parameter description
Endress+Hauser 63
Application → Sensor → Linearization → Call./v. Dusen coeff. R0, A, B, C →  77
Polynomial coeff. R0, A, B →  78
Sensor lower limit →  78
Sensor upper limit →  79
Application → Current output → 4mA value →  79
20mA value →  79
Failure mode →  79
Failure current →  80
Current trimming 4 mA →  80
Current trimming 20 mA →  81
Damping →  81
Application → HART configuration → Assign current output (PV) →  81
Assign SV →  82
Assign TV →  82
Assign QV →  82
HART address →  82
No. of preambles →  83
System→ Device management→ HART short tag →  83
Device tag →  83
Locking status →  84
Device reset →  84
Configuration counter →  84
Configuration changed →  85
Reset configuration changed flag →  85
System→ User management → Define password → New password →  86
Confirm new password →  86
Status password entry →  86
Change user role → Password
1)
→  85
Status password entry →  85
Reset password → Reset password →  87
Status password entry →  86
Change password →
Old password →  85
New password →  86
Confirm new password →  86
Status password entry →  88
Delete password → Delete password →  88
1) The required user role must first be selected here when operating the device via the SmartBlue App.