Endress+Hauser Levelflex M FMP40 - On-site operation; Remote operation

Operation Levelflex M FMP40 FOUNDATION Fieldbus
40 Endress+Hauser
5.1.1 On-site operation
Options for on-site operation
•Display and operating module VU331
•Endress+Hauser operating software "FieldCare"
Parameter access by on-site operation
The following parameters can be accessed by on-site operation:
•Parameters of the device specific blocks (Sensor Block, Diagnostic Block, Display Block)
•Endress+Hauser service parameters
•in the Resource Block: "Instrument Tag", "Instrument ID", "Instrument Revision", "DD Revision"
(read only)
L00-FMU4XXXX-02-00-00-YY-005
The highlighted parameters can be edited by on-site operation.
5.1.2 Remote operation
Options for remote operation
•FOUNDATION Fieldbus configuration tool (e.g. DeltaV or ControlCare)
•Handheld terminal Field Communicator 375, 475
Parameter access by remote operation
The following parameters can be accessed by remote operation:
•Parameters of the device specific blocks (Sensor Block, Diagnostic Block, Display Block)
•Parameters of the FOUNDATION Fieldbus function blocks
L00-FMU4XXXX-02-00-00-YY-006
The highlighted parameters can be edited by remote operation.
Endress+Hauser
Service-Parameter
Sensorblock
Diagnoseblock
Display-Block
Resource Block
AI-Block 1
AI-Block 2
PIDBlock
Arithmetik-Block
Input-Selector-Block
Signal-Charact.-Block
Integrator-Block
Endress+Hauser
Service-Parameter
Sensorblock
Diagnoseblock
Display-Block
Resource Block
AI-Block 1
AI-Block 2
PIDBlock
Arithmetik-Block
Input-Selector-Block
Signal-Charact.-Block
Integrator-Block