Commissioning Levelflex M FMP40 FOUNDATION Fieldbus
56 Endress+Hauser
6.5 Commissioning by the display and operating module
VU331
6.5.1 Power up device
When the device is switched on for the first time, the following messages appear in a sequence of
5 s on the display: software version, communication protocoll and language selection
The "basic setup" (00) function group lists all the functions which are required for a standard
measurement tast to commission the Levelflex M. When you have complete your input for a
function, the next function appears automatically. In this way, you are guided through the complete
calibration.
Function "measured value" (000)
This function displays the current measured value in the selected unit (see "customer unit" (042)
function). The number of digits after decimal point can be selected in the "no.of decimals" (095)
function.
⇒
Select the language (this message appears the first time
the device is switched on)
⇓
Select the basic unit (this message appears the first time
the device is switched on)
⇓
The current measured value is displayed
⇓
After pressing
F
, you are taken to the group selection
This selection enables you to perform the basic standard
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–
To Next Page
Loading...
