Endress+Hauser Liquistation CSF34 - Page 26

Electrical connection Liquistation CSF34
26 Endress+Hauser
6.1.5 Connecting sensors with Memosens protocol
‣
Sensor cable connected directly
Connect the sensor cable to the terminal connector of the 2DS, or of the BASE2-E
module.
In the case of a single-cannel device:
The left-hand Memosens input on basic module must be used!
6.1.6 Sensor connection
‣
Guide the sensor cable via the rear panel to the controller housing towards the front.
→  39 and →  40

A0016360
 18 Gland to the controller
Only use terminated original cables where possible.
GN/YE
YE
GN
BN
WH
GND
+
–
Com A
Com B
GY
A0024019
 19 Example of a Memosens CYK10 data cable