Endress+Hauser Micropilot FMR56 - Default Chapter; Table of Contents

Micropilot FMR56, FMR57 FOUNDATION Fieldbus Table of contents
Endress+Hauser 3
Table of contents
1 Wichtige Hinweise zum Dokument ................................................ 4
1.1 Symbols ............................................................................. 4
1.2 Terms and abbreviations ................................................................. 7
1.3 Registered trademarks .................................................................. 8
2 Basic safety instructions .......................................................... 9
2.1 Requirements for the personnel ............................................................ 9
2.2 Designated use ........................................................................ 9
2.3 Workplace safety ..................................................................... 10
2.4 Operational safety .....................................................................10
2.5 Product safety ........................................................................ 10
3 Product description .............................................................. 12
3.1 Product design ....................................................................... 12
4 Incoming acceptance and product identification ................................. 13
4.1 Incoming acceptance ................................................................... 13
4.2 Product identification .................................................................. 14
5 Storage, Transport ............................................................... 15
5.1 Storage conditions .................................................................... 15
5.2 Transport product to the measuring point ................................................... 15
6 Installation ...................................................................... 16
6.1 Installation conditions .................................................................. 16
6.2 Measuring conditions .................................................................. 22
6.3 Installation in vessel (free space) .......................................................... 23
6.4 Container with heat insulation ........................................................... 32
6.5 Turning the transmitter housing .......................................................... 32
6.6 Turning the display .................................................................... 33
6.7 Post-installation check ................................................................. 34
7 Electrical connection ............................................................ 35
7.1 Connection conditions .................................................................. 35
7.2 Connecting the measuring device ......................................................... 41
7.3 Post-connection check ..................................................................44
8 Integration into a FOUNDATION Fieldbus network ............................... 44
8.1 Device Description (DD) ................................................................. 44
8.2 Integration into the FOUNDATION Fieldbus network ........................................... 45
8.3 Device identification and addressing ....................................................... 45
8.4 Block model ......................................................................... 47
8.5 Assignment of the measured values (CHANNEL) in an AI Block ................................... 48
8.6 Methods ............................................................................ 50
9 Commissioning via wizard ....................................................... 51
10 Commissioning (via operating menu) ............................................ 52
10.1 Display and operating module ............................................................ 52
10.2 Operating menu ...................................................................... 55
10.3 Unlock the device ..................................................................... 56
10.4 Setting the operating language ........................................................... 56
10.5 Configuration of a level measurement ...................................................... 57
10.6 User-specific applications ............................................................... 58
11 Commissioning (block-based operation) ......................................... 58
11.1 Block configuration .................................................................... 58