Endress+Hauser Micropilot FMR56 - Post-Installation Check

Installation Micropilot FMR56, FMR57 FOUNDATION Fieldbus
34 Endress+Hauser
6.6.3 Closing electronics compartment cover
2.
2,5 Nm
3 mm
1.
A0021451
1. Screw back firmly electronics compartment cover.
2. Turning securing clamp 90 ° clockwise and tighten the clamp with 2.5 Nm using the
Allen key (3 mm).
6.7 Post-installation check
 Is the device undamaged (visual inspection)?

Does the device conform to the measuring point specifications?
For example:
• Process temperature
• Process pressure (refer to the chapter on "Material load curves" of the "Technical Information"
document)
• Ambient temperature range
• Measuring range
 Are the measuring point identification and labeling correct (visual inspection)?
 Is the device adequately protected from precipitation and direct sunlight?
 Are the securing screw and securing clamp tightened securely?