Endress+Hauser Profi Bus Levelflex M FMP40 - Function Empty Calibr. (005)

3 Function group "basic setup" (00) Levelflex M
20 Endress+Hauser
Selection:
•length ok
• too short
• too long
After selection "length too short" or "length too long", the calculation of the new value need approx.
10 s.
3.10 Function "empty calibr." (005)
This function is used to enter the distance from the flange (reference point of the measurement) to
the minimum level (=zero).
⇒
ENDRESS + HAUSER
E
+
–
0%
E
E = empty calibration (= zero)
E
max
= probe length – lower blocking distance