Endress+Hauser Profi Bus Levelflex M FMP40 Function Manual

Levelflex M 1 Notes on use
Endress+Hauser 11
1.6 Commissioning
1.6.1 Switching on the measuring device
When the instrument is switched on for the first time, the following messages appear on the display:
⇒
⇓
After 5 s, the following message appears
⇓
Nach 5 s erscheint (z.B. bei HART Geräten)
⇓
After 5 s or after you have pressed F the following mes-
sage appears
Select the language
(this message appears the first time the instrument is
switched on)
⇓
Select the basic unit
(this message appears the first time the instrument is
switched on)
⇓
⇒
The current measured value is displayed
⇓
After F is pressed, you reach the group selection.
This selection enables you to perform the basic setup
ENDRESS + HAUSER
E
+
–

Endress+Hauser Profi Bus Levelflex M FMP40 Specifications

General

Brand	Endress+Hauser
Model	Profi Bus Levelflex M FMP40
Category	Measuring Instruments
Language	English