Endress+Hauser Profi Bus Levelflex M FMP40 - 9 Function Group Envelope Curve (0 E); Function Plot Settings (0 E1); Function Recording Curve (0 E2)

9 Function group "envelope curve" (0E) Levelflex M
56 Endress+Hauser
9 Function group "envelope curve" (0E)
9.1 Function "plot settings" (0E1)
Here select which information is displayed in the LCD:
• envelope curve
• substracted signal
•mapping
9.2 Function "recording curve" (0E2)
This function defines whether the envelope curve is read as a
• single curve
or
• cyclic.
!
Note!
If the cyclical envelope curve is active in the display, the measured variable is refreshed in a slower
cycle time. It is therefore recommended to exit the envelope curve display after optimising the
measuring point.
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–
⇒
ENDRESS + HAUSER
E
+
–