Endress+Hauser Proline Promag 300 - Verification or Calibration; Version History

Proline Promag 300 HART Appendix
Endress+Hauser 49
9.2.3 Parameter settings for the SIL mode
A0049164
9.3 Verification or calibration
The SIL mode must be disabled in order to verify the measuring point with Heartbeat
Technology or calibrate the measuring point.
NOTICE
To use the device in a safety function again following a verification or calibration, the
configuration of the measuring point must be checked and the SIL mode must be enabled
again.
‣
Activation of the SIL mode →  21.
9.4 Version history
Version Changes Valid as of firmware version
SD01740D/06/xx/07.22 Changes: Operating Instructions for the
device
01.06.zz (HART; from delivery date August 2,
2022)
SD01740D/06/xx/06.20 Addition, Device Model A1/A2 & option
CC (4 to 20mA HART Ex-i active)
01.05.zz (HART; from delivery date September
16, 2019)