Proline Promag 300 HART Manufacturer's Declaration
Endress+Hauser 5
1.1 Safety-related characteristic values
General
Device designation and permitted
versions
5H3B (Promag H 300)
5P3B (Promag P 300)
5W3B (Promag W 300)
Order code for "Output; input 1":
• Option BA "4-20mA HART"
• Option BB "4-20mA + Wireless HART"
• Option CA "4-20mA HART Ex-i passive"
• Option CB "4-20mA Ex-i + Wireless HART"
• Option CC "4-20mA HART Ex-i active"
Order code for "Output; input 2":
All options
Order code for "Output; input 3":
All options
Order code for "Additional approval":
Option LA "SIL"
Safety-related output signal 4 to 20 mA (output; input 1)
Failure current ≤ 3.6 mA or ≥ 21 mA
Assessed measured variable/
function
Volume flow monitoring
Safety function(s) Min., Max., Range
Device type according to IEC
61508-2
Type A Type B
Operating mode Low Demand Mode High Demand Mode Continuous Mode
1)
Valid hardware version (main
electronics)
From delivery date October 1, 2017
Valid firmware version 01.01.zz and higher (HART; from delivery date October 1, 2017)
Safety manual SD01740D
Type of assessment
(only 1 version can be selected)
Complete HW/SW assessment in the context of development including
FMEDA and change process according to IEC 61508-2, 3
Assessment of evidence for proven-in-use HW/SW including FMEDA and
change process according to IEC 61508-2, 3
Analysis of HW/SW field data for evidence of "prior use" according to IEC
61511
Assessment by FMEDA according to IEC 61508-2 for devices without software
Assessment by (including report
no. + FMEDA data source)
TÜV Rheinland Industrie Service GmbH – Certificate No. 968/FSP 1408.00/17
Test documents Development documents, test reports, data sheets
1) No continuous operation in accordance with IEC 61508: 2011 (Section 3.5.16).
To Next Page
Loading...
